aem wideband seting

[lee98talon]

couldnt really get a led on a search on which setting im suppose to be in on my AEM wideband UEGO, p00, p01, p02, p03, or p04. Currently running dsmlink, with the narrow band simulator. And i placed my aem wideband sensor where the front o2 sensor is. so, i only have one front o2 sensor, which is the wideband o2 sensor.

currently got the wb set to p00.

 

[oldman_tau]

i also wanted to learn from this, im for sure members will be able to share ideas here

 

[Paintballaa5]

Also seeking info.. Hoping someone can go into a little more detail on how to get Link to display the correct values.

 

[clipto]

It's setup straight out the box plug and play. But if you must know...
The AEM default position is (P0). When set to (P0) (Figure 10A), the gauge displays
AFR values. (P1) is the same as (P0), except the gauge displays lambda values. These
settings (P1 and P0) implement a linear calibration with the most useful voltage range
possible (0-5V). The AFR calibration (P2) is linear and similar to (P1) with a smaller
voltage range (1-2V). The AFR calibration (P3) emulates the Autronic Wideband O2
Sensor calibration (0-1V). The AFR calibration (P4) emulates a non-linear Nernst Cell
calibration (0-1V)

 

[lee98talon]

the previous guy installed the wb and I read some where that im suppose to set the wb at p0 or p01 if i got a stand alone ecu and narrow band simulated on dsmlink. was just making sure because i don't think my wb is cycling right on dsmlink. it bounces at .5 to .8 Nothing in between(maybe here and there, but most of the time it sits at .5 or .8). close loop shows, 1, which should means im in close loop.

Also seeking info.. Hoping someone can go into a little more detail on how to get Link to display the correct values.

which values are you look at?