Porting part deux!

[ITSME4G63]

Ported this stock 14b turbine housing out, what chall think? better job than last time huh? This time I even used some marble polish via a high speed brush attachment. The gasket on top of that is a mitsu 7cm.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

I think it came out rather good. Tell me what chall think.

 

[92DSMErdrick]

i think it looks pritty good. That's what im gonna be doing with my 14b this year, picked up a evo3 ported mani last week which is 7cm. Can't wait to see how that combo will perform. Going to spool too quick for my FWD

 

[phishin84]

Are you going to port the rest of the opening it to fit that 7cm completely? Looks nice though, a lot smoother than I got mine the first time around.

 

[daren_p]

Defently looks better then the first try . I guessing your not going to run the inlet ring anymore? If so I would take that step out completely, otherwise you are going to cause turbulence.

 

[ITSME4G63]

Defently looks better then the first try . I guessing your not going to run the inlet ring anymore? If so I would take that step out completely, otherwise you are going to cause turbulence.

there is no step, the gasket is on top makign it look like so. If I port this anymore, Im afraid that there would be a chance of the gasket missalingin somehow in regards to the alignment of the gasket to the opening upon installation

 

[daren_p]

there is no step, the gasket is on top makign it look like so. If I port this anymore, Im afraid that there would be a chance of the gasket missalingin somehow in regards to the alignment of the gasket to the opening upon installation

Ya I figured that out after I took a second look, good old wireless internet crapped out when I was trying to edit my post

 

[CanadianTSi]

Hog it out all the way so it matches the Gasket...

 

[MILITISINVICTUS]

Hog it out all the way so it matches the Gasket...

I agree, the gasket mismatch is creating yet another step for you to worry about, Portmeister.

 

[ITSME4G63]

alright then, what chall think of this o2 housing porting job then?

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.