SBR 2G FMIC w/ 4in intake pipe

[BREW]

For those who use the 2g FMIC from Slowboy, and also run an intake pipe for the S cover. I want to know if this combination is possible. My fear is that the intake pipe will not clear the short routing of the intercooler. If indeed you run this setup or something very similar, if you could please post a picture or atleast give reassurance that it is possible, I would be greatfull.

Thanks in advance

Brew

 

[99gst_racer]

It will fit. I run the SBR FMIC w/ short route piping on my 2G and I have a 3" intake pipe and there is still an abundance of space around that area.

I don't have any pics on my work computer, and I still dont have internet access at my new house, but if I figure something out, I'll try to get you a picture.

 

[BREW]

It will fit. I run the SBR FMIC w/ short route piping on my 2G and I have a 3" intake pipe and there is still an abundance of space around that area.

I don't have any pics on my work computer, and I still dont have internet access at my new house, but if I figure something out, I'll try to get you a picture.

I was thinking that it would. Didn't want to order the turbo with the 4 inch cover if it wasn't going to work with my setup. Whenever you get the time to post the pics, not in that much of a hurry, but I would like to see them.

Thanks again

Brew

 

[crunchymilk]

I run the slowboy2g. When it gets daylight tommorrow I'll take a pic. You should be fine, but a pics wouldn't hurt.