long route piping to short route on greddy 24r?

[fulanititoo8198]

My car is down right now so I'm basically just tinkering around with it. I have a greddy 24r fmic. I was wondering if it's possible to take the original piping locations and weld them shut. Open new holes up in the back of the end tanks and make my own short route pipes for it.I've never seen it done and can't find any threads on it. So can it be done why or why not?

Thanks
C

 

[94awdcoupe]

just sell the FMIC with the pipes and just get a dejon-tool or agp kit.

 

[project_tsi]

It can be done, sure. Its just you have to find a welder who can weld aluminum, and also the IC needs to be pressure tested after its finished. It may just be easier if you were to cut off the original end tanks and have some fabbed up out of aluminum, that way it would look better and the design could be unique. Don't know how much it would cost, maybe a few hundred bucks, maybe not. If your IC's in bad shape, you may be better off buying a SBR or AGP or likeways core.