Almost there post some more pics later of the emanange and e-01. I wont be able to sleep I am so excited to get it done!!!!!

Looks bad ass!

I'm guessing Tial wastegate right? What kind of turbo and manifold?

You might want to re position your upper radiator hose. It is going to melt unless you wrap it or angle it or do both.

http://memimage.cardomain.net/member_images/8/web/704000-704999/704821_9.jpg

look good. you should cut away the top part of the intercooler/mouth opening so allow for more air.

Yeah I am definetly cutting that part away just want to get everything else working then work on the extras. Thanks for the hint on the radiator hose would have never thought of that. Yeah it's a Tail wastegate cant wait to hear what it sounds like. It's a PTE 50 trim with a manifold from fastfabrications with Jet Hot sterling silver coat. Do you guys have any idea how long my stock clutch is going to last if I drive it nicely since I am afraid that is the next thing thats going to break and I don't have money for that after all this!!

are you going to run only 1 radiator fan than cause from the looks of it the fan by the turbo isnt going to fit

I am keeping one stock fan but replacing the other one with a thinner one only costed me $20-00. Hope its works otherwise I will have to figure something else out.

All I have to say is DAAYUMM

oh and did you rebuild the motor too, or did you clean it up all nice like. What did you spend on your project thus far

oh again fuggin sweet

Thanks for all the compliments!! YEah I did a rebuild about 2000 miles ago with the howell performance bottom end and some crane turbo cams. Thanks again for the compliments bc my roommates dont get why I spend my life on dsmtuners and my car but it should all be worth it after everything is done Cost wise a sh@t load money it was suppose to pay for my last year of tuition but I figured what the hell why not.