Engine Cylinder Head

[STL91GST]

Ok I changed the Cylinder Head on my '91 GST 5Spd and I installed everything except some hoses 3 to be exact and a electrical connection right behind the Intake Manifold......

so i turned on my car after like 3 or 4 months of it being in my garage and it turned over at first and didn't want to start so I moved the distributor completely to the right and it turned on without a problem but when i accelerate the car it goes high as if your punching it when you only acel a little bit............so i move the car and it feels as if it has no HP to move......any suggestions?

 

[turboholic]

Originally posted by STL91GST
Ok I changed the Cylinder Head on my '91 GST 5Spd and I installed everything except some hoses 3 to be exact and a electrical connection right behind the Intake Manifold......

so i turned on my car after like 3 or 4 months of it being in my garage and it turned over at first and didn't want to start so I moved the distributor completely to the right and it turned on without a problem but when i accelerate the car it goes high as if your punching it when you only acel a little bit............so i move the car and it feels as if it has no HP to move......any suggestions?

-It's very difficult to understand your post without punctuation in it.

-3 hoses, are they vacuum hoses or what? the knock sensor is not hook up? there is no distributor on a 4G63, do you mean the cam angle sensor? I think your timing is off.

 

[STL91GST]

ok your standing in front of the engine bay,,,,,,,,,,,,,,,the accelerator cable runs into a little square grey box attached to the back wall and then it comes out to the right side of the engine into a round pump looking thing and then out of that there a hose which i dont know where it goes.....


theres from the back right wall theres 2 big electric connecters and four hoses come out of that i attached two but theres two other hoses that i dont know where they go.


isn't the distributor the round part with the two lug nuts attached to the right side of the head?,,,it moves from left to right and vise versa

if there were pictures to see what goes where but my book has a total different engine than mine. so no help..any pictures?

 

[turboholic]

Originally posted by STL91GST
ok your standing in front of the engine bay,,,,,,,,,,,,,,,the accelerator cable runs into a little square grey box attached to the back wall and then it comes out to the right side of the engine into a round pump looking thing and then out of that there a hose which i dont know where it goes.....


theres from the back right wall theres 2 big electric connecters and four hoses come out of that i attached two but theres two other hoses that i dont know where they go.


isn't the distributor the round part with the two lug nuts attached to the right side of the head?,,,it moves from left to right and vise versa

- He has the vacuum hose lay out.
-The gray box is the cruise control vacuum pump. the thingy on the end of the intake cam is the 'cam angle sensor + top dead center sensor' (in the same unit).
-If you want better picture, get the cd manual .