qcontinuum software issues

[Pooldog99]

I followed the Apr-05 thread about the alternative to "palmofpoop" to the end. Has everyone been able to get thier Palm M100 to make this software work? I have fiddled with the settings and it still reads "initializing".

I am using the multiplex and the hotstink cord to my m100.

I would like to see what everyone has for thier settings so I can duplicate.

By the way, this rookie crap stinks.

 

[DiamondStarM]

That was the thread I started a while back. The software is actually called OBDGauge, qcontinuum is just part of the wed address.

Since I brought it up in that thread, these are the settings I've used with my palm hotsync cable, Multiplex Engineering cable, and M100:

Optionsreferences:

Language-English
Display-Hide both
Units-U.S.
Scan-Displayed Sensors
Graph-Line
Interface-Multiplex

Then under setup I have

Baud-19200
Address-25
Protocol-ISO

And that should work if all your hardware is functioning properly and software is installed good. Now go log something!

 

[Pooldog99]

In addition to this topic has anyone been able to palm log with a usb connection to the multiplex at all? I also have a newer palm that i am looking to use instead of the old M100 that I have.