New clutch/tranny now i can't shift

[Empyrials]

ok i just installed a new clutch and tranny, i've blead the clutch, and adjusted it. and still i can't shift into a gear while car is started. when off i can Somewhat move into other gears, not all of them and not very well.

i also installed a new clutch line during this. but it doesn't seem to me leaking or anything. And my Slave cyl pushes the clutch fork all the way ot the left when you push on the clutch.


Any idea? very frustrated atm.

Oh ya, when you install the tranny, the clutch fork is supose to sit near the middle, but towards the driver's side right?.... mine sits as far driverside as it can, that bad?

 

[Empyrials]

i checked with all my friends and they couldn't help me, any ideas?

 

[gnes100]

I just did the same job and am having the same problem i havnt had time to look into it .. but i am gonna try and pull the tranny out and figure it out

 

[turboholic]

http://www.roadraceengineering.com/clutchandflywheeltech.htm

 

[Empyrials]

http://www.roadraceengineering.com/clutchandflywheeltech.htm

So that does nothing for me... i've been there several times just to make sure i didn't miss any info in there, both before i did the tranny swap and after.

thanks though

 

[gnes100]

Goo all the way to the bottom and read about the shift fork being worn thats what i think my problem is

 

[Empyrials]

Goo all the way to the bottom and read about the shift fork being worn thats what i think my problem is

You must be logged in to view this image or video.

ya my first thought was that, but my fork was on the other side, which i thought was wierd but still in the OK zone from what i've been told ¿?