Indiglo Boost controller lights up but NO PSI or VACCUME READINGS

[SpoolingSpyder]

About 2 days ago, I notice my boost gauge lights up. But at idle and in boost the needle is stuck at 0. I tried to look for some loose vacumme hoses and found 1. I re connected my hose to the intake maifold(where it was before anything went wrong) and its still not reading anything. Is this a gauge malfunction? if it is why would the light still come on but no readings? Or is there something that I need to do? like finding out where Im tapping the vaccume from? Any advise please give..!!!

 

[flinguist]

I had a similar problem, and it was because the tubing to my boost gage was pinched. Worth a try.

 

[Coldandafraid]

Why light... but no boost readings? That would be because the needle is moved by psi/vac changes in the tube... and the light is turned on by electricity. Meaning... something is wrong with the vac line... but the electrical wires are still fine.

 

[SikRacing97GST]

I would definately check the vac hose comming down from the guage to where you've tapped it in and make sure it not piched somewhere around the firewall or wherever you've got it through.

 

[SpoolingSpyder]

Thanks for the advise my friends. The problem will be solved later on this evening when the sun goes down. Its 105 degrees atm..OUCH that BURNS..!