Please a litle help on hose routing for a external waste gate

[Snake]

Well I youst finished installing a turbonetics 35mm external waste gate on my car.
I have doubts on the correct way to intall back my XMB(extreme motorsport manual boost controler)
On the external wastegate there are 2 fitings one say BOOST and the other VAC.

Can someone PLEASE provide me with a diagram on how to install my manual boost controler the corect way.

Its to my understanding that I dont need to use the VAC port to operate it correctly since I dont run a electronic boost controler.
But I need to be 100% sure.

Thanks in advance!!

 

[quest49s]

I would imagine you just run the MBC to the boost port on the 35mm from a boost source(BOV line, turbo Elbow) Then again I'm not 100% because I run an AVC-R on my turbonetics 35mm where you use both ports like you said.

 

[Snake]

Well what I think the most logical thing to do is to run a line from the turbo elbow to the manual boost controller and then to the boost port on the external waste gate and leave the vacum port open.
But I would like someone to provide me with a diagram of there set-up or a link with a diagram of some sort.

 

[quest49s]

why don't you just hook it up like you said and open the MBC all the way so you will be at minimum boost and take it for a rip and watch your boost gauge to see if it opens or to let off if it doesn't and boost gets to high.

Jon Hebbeln

 

[TSiAWD666]

Connect the boost port (should be the side port) to the output of the mbc, and leave the vacuum port open to atmosphere.

 

[Snake]

Thanks man I youst wanted to be sure.
Tonigth is tuning nigth so I will hook it up like that.
Got to wait untill midnigth so I have the road all to myself.
I am plannig on going for 18psi.With my curent setup.
Wish me lots of LUCK so I dont FU@#%& it up while tuning it!