A couple of questions

[99silvergs]

I just got my nx express wet kit and i have a couple of questions:

1- when they say connect to 12V i suppose to hook it up to like the ignition wires right? Where are those wires located?

2- do i need a special tool to take off that schraeder valve thing on the fuel rail. i read from the zex writeup from i think gsgofast or something like that, that you can get that tool from autozone ... but do i need it to take it off?

3- why cant i see the attachments that you guys post????

Thats about it, probably going to install it saturday.

Thanks

 

[DSMJim]

I just got my nx express wet kit and i have a couple of questions:

1- when they say connect to 12V i suppose to hook it up to like the ignition wires right? Where are those wires located?

2- do i need a special tool to take off that schraeder valve thing on the fuel rail. i read from the zex writeup from i think gsgofast or something like that, that you can get that tool from autozone ... but do i need it to take it off?

3- why cant i see the attachments that you guys post????

Thats about it, probably going to install it saturday.

Thanks

12V is any electrical source in the car. You can run a wire from your battery or hook into an empty spot in your fuse panel. It doesn't really matter.

The schreader valve comes off with vice grips if your in a pinch but be careful not to bend the cap or break it. The tool from autozone is better. That is where the fuel will be supplied from when you spray the nitrous and fuel mixture.

As for attachments, they are pictures and they should show up. If your seeing red X's in boxes or nothing then it's because the pictures have been moved or deleted and can not be found.

 

[99silvergs]

ok thanks .. well i just found out that my kit did not come with the plug thing to the test port, so im going to have to cut into the fuel line. Is the fuel line itself by the test port or the opposite side????


And where is a good spot to send the wires from the engine bay inside the car? Do i need to drill a whole or something ???

Thanks

 

[DSMJim]

ok thanks .. well i just found out that my kit did not come with the plug thing to the test port, so im going to have to cut into the fuel line. Is the fuel line itself by the test port or the opposite side????


And where is a good spot to send the wires from the engine bay inside the car? Do i need to drill a whole or something ???

Thanks

Not sure about where to grab the fuel from on a 420a, dont have one and never really done any serious work on one to remember. Under the brake booster there is a spot to put the wires through.

 

[MrPikolo]

Not sure about where to grab the fuel from on a 420a, dont have one and never really done any serious work on one to remember. Under the brake booster there is a spot to put the wires through.

Right from the test port if i'm not mistaken.