fixing stock motor mounts

[Motohead1]

Ok i have done a few searches but havent come up with much. What i need to know is what is the best thing to use to help fix a stock motor mount? I have seen a few threads mention guys using a silicone that hardens to reinforce the stock mounts. what is it and where can i get it? I installed poly mounts but its just too buzzy.

 

[turboholic]

-It's 3M's Window-Weld, will need a culking gun, kind of messy, mounts needed to be off the car, will need about 24 hrs to cure, one tube will enough for one car(4 mounts), if you want even stiffer mounts, you can get a cheap white plastic cutting board, cut into strip, fill up the gap then apply the window weld.

 

[MyRidzPhucked]

May as well buy new ones... look for a full kit for cheap. Polyurtherane will be a bit more annoying but better in the end

 

[Defiant]

http://www.raktron.com/misc/mt.htm

http://www.turbomirage.com/mountinserts.htm

http://importnut.net/motormount.htm

 

[Motohead1]

Thanks guys that just the info i was lookin for. Anyone want to buy a full ES poly mount kit?