no spark in cyl 2 and 3 after maft install HELP

[caseclipsegst]

Ok so i just installed my nee maft translator and sensor on my 95 gst.. i hooked up the white wire from the maft to the white wire on the transistor. Well i started it up and it idled great for two minutes with no problems then all of a sudden the engine bogged down and started shaking. I lost spark to cylinders two and three. I recently put a new cam sensor crank sensor plugs and wires and two new coil packs. Please if you have any input on this i would really like to know. Ive searched the web and forum and most are saying it could be the powrr transistor??

 

[DiamondStar90]

try looking at your coil pack and wires and make sure you have no bare wires... also is there no spark coming out of the coil packs for cylinder 2 and 3?

and join texas DSM group and meets and we can help you with it

 

[allezgrand]

Have you double checked to make sure that the white wire that you ran to the transistor is not shorting out anywhere? ...If you suck power from the transistor, that can cause what you're describing.

 

[caseclipsegst]

It was the transistor