ID turbine housing

[panamarojo]

080 / 78-11020 is the numbers on the turbine housing. A 14b is installed into it.

 

[Bud92gsx]

It's either a 6cm housing or 7cm housing.

 

[panamarojo]

Hmm from what I read the 060 is the 6cm and the 070 is a 7 cm, but what is the 080?

 

[JusMX141]

Not something you have. You're mistaking the 060 for 080 as your 78-11020 part number clearly depicts your housing as being 6cm.

The 8cm housings are very rare and are clearly identifiable:

You must be logged in to view this image or video.

 

[CrackedDSM]

What turbos did the 8cm housing come on, Jus?

 

[JusMX141]

None- to my knowledge it was intended to be a factory upgrade housing. It actually has a 54mm inlet, the same as a 14B or T25.

The housing used in this example has the inlet ported to match a 7cm gasket (60mm), but you must be very careful porting an 8cm housing this far as you can easily port a hole right in the side of the housing. They also become much more prone to serious cracking when ported like this: http://www.dsmtuners.com/forums/turbo-system-tech/394644-turbo-housing-id-help-needed.html

 

[panamarojo]

Could it be a mis print? Because I had a few other people just read it and we are seeing an 8.

 

[JusMX141]

No misprint- if it says 11020, it's a 6cm housing.

 

[RedTsi_PR]

Are there any 8cm housing made by mistu?

 

[JusMX141]

Are there any 8cm housing made by mistu?

Ummmmm.....

 

[panamarojo]

I will take a picture by next week. It says 080. I looked at it carefully and there is no 6 in there.