Where to Connect Manual Boost Controller??

[DsmTurbo12]

Okay so i have a 61 trimm Garett Turbo and it dosen't have a nipple like most other turbos do. I know that the one end of the MBC will connect to the wastegate but any suggestions on where the other end should go? I've heard connecting the other end to your BOV is unsafe so that's why im asking. Thankyou

 

[crash89]

You can always drill and tap your own pressure souce on the comp housing or onto your Lower IC pipe.

 

[92AWDHX40]

http://www.dsmtuners.com/forums/articles-turbo-system-intercooler/237982-best-way-install-mbc.html

 

[Quicksilver1695]

^ +1. put a nipple on the lower I/C piping. one line from wastegate and one to the I/C pipe.

 

[19Eclipse90]

http://www.dsmtuners.com/forums/bolt-tech/269122-resolved-need-j-pipe-nipple.html
http://www.dsmtuners.com/forums/articles-turbo-system-intercooler/387331-adding-boost-source-16g-turbo-compressor-outlet.html
http://www.dsmtuners.com/forums/newbie-forum/255444-brought-used-jpipe-no-nipple.html
http://www.dsmtuners.com/forums/newbie-forum/237719-j-pipe-nipple.html
http://www.dsmtuners.com/forums/newbie-forum/224745-where-hook-up-mbc-i-have-fmic-no-nipple.html

Basically, you want it as close to the compressor housing as you can get. You can use the hot side (right after the compressor) intercooler piping if you don't have a j-pipe. Absolutely do not use the BOV line.

 

[DsmTurbo12]

thanks a lot guys this helped very muchh

 

[razrman8]

If your question has been asnwered, you should mark this thread resolved. It is in the black bar under thread tools.