COP plate measurements

[shaggyslaser]

I am at work and I have a steel plate that I would like to start making my COP setup. When I received my Laser, I had no plate over my spark plugs, so I can't exactly transfer from the old one. Is there anyone out there with a diagram and some measurements? If not, I'll get to it eventually and post up the measurements, but this would be appreciated considering I have nothing to do right now.

 

[shaggyslaser]

No one has these by chance?

 

[324vr4]

Get your OEM plug cover and trace it on your metal stock and measure off that...then just get the centers of the plug holes measured in and blah blah blah....or use a piece of cardboard to get your dimensions off of that....be a fabricator if that's your goal...

 

[shaggyslaser]

As said in the original post, I don't have the plug cover.

 

[Ghostriderdsm]

14(3/4)" LONG

3(7/16)" Width

5" width(part the goes past the oil cap

DIAGRAM!

You must be logged in to view this image or video.

 

[DSM1G90]

...or, you can go out to a yard and see if any is out there ot be had...

Or, go to a mitz dealership and order a new one.

 

[shaggyslaser]

MS Paint FTW. I'll probably just buy one at a junkyard, make it, and then post up measurements.