disecting a de-stroker kit

[skyrone]

Ok so i wan't to do a destroker engine in my 2g. The kit from sbr is not really unreasonable i just have some hookups with a shop that might be able to get me the individual parts cheaper and give me more money for getting the head done. So far from talking with some people i've figured out that you need a 4g64 block, a 4g63 crank, 162mm long rods, and a "custom piston". I was wondering if anybody had exact specs on what a stock 4g64 rod is and stuff so that i could figure this out. To me it seems like if I just got forged 4g64 pistons id be fine but idk any input?

 

[JeffGST]

A standard 4G64 rod is a 5.900 inch rod just like in the 4G63.

5.900in = 149.86mm

You cannot use a standard 4G64 piston because of the different pin offset in the piston. The Wiseco's are the only pistons I know of that you can use with the Manley 162mm rods.

 

[skyrone]

ok but thats all i need is weisco pistons for the 4g64 nothing special about them?

 

[JeffGST]

EDIT: After doing some research I have found that a 4G64 block, 4G63 crank, 162mm rod and a 4G64 stroker piston is all you need.

 

[skyrone]

so like a 4g64 stroker piston at stock width? ### the only stroker 4g64 i know of is a 2.6 but that is bored i believe