want to use A/N insted of banjo bolt

[WILOWNU]

so i am using a braided steel line for my oil feed and i was wondering if anyone knows the threading i need to use instead of the banjo bolt. like whether it is a -4 AN or if it is pipe thread or what.

thanks!

 

[92awddsm]

Cant tell you what the thread is if you dont tell us what turbo it is.

 

[WILOWNU]

its the fitting going into the head, not into the turbo. failed to mention that.

 

[92awddsm]

its the fitting going into the head, not into the turbo. failed to mention that.

It is 10mmx1.25 thread. You would have to get a 10x1.25to -4an adapter. before installing, you will probably have to grind the length shorter of the 10mm portion of the adapter some so it doesnt block the oil cross passage in the head. You will also have to use a crush washer against the head in order for the fitting to seal. For the hose, just get a -4 90* male to female fitting to replace the screw on banjo fitting. The adapters are available, you just need to find them. Remember, google is your friend.

PS- This is given that your current feed line is -4 and not -3. If it is -3, you may have to run a couple of stacked adapters. I have never seen 10mm to -3 fittings but have seen 10-4 and 4-3 adapters.