Approximately How off WAS YOUR REAR CAMBER AFTER DROP?? I NEED THIS INFO BEFORE I....

[MarkAngelo05]

Hi there, I have done many searches, there are many like topics, but nothin came close to what i want to know before monday afternoon..

My car is lowered approximately 2 inches, maybe more, the 225/40/18 inch tires are about 2 fingers from going into the fenders...

I installed the RRE CAMBER KIT with 1 additional washer on each spacer. I still notice my tires butteryfly a little bit. I need it to be within factory specs for "reconstruction permit" here in hawaii to make my car street legal...

I was wondering if anyone knows the approximate camber it is off by the amount of drop??

Thanks!

Mark

 

[DGajre777]

The RRE rear kit is made for the Eibach Pro kit, not a 2" drop. You either need a bigger bolt, more washers or another kit made for a bigger range, like this one - http://www.extremepsi.com/store/customer/product.php?productid=18785&cat=927&page=1

 

[MarkAngelo05]

Got my alignment done, this sux ### my front camber does not meet factory specs. My rear does though with the RRE rear camber correction kit and one extra washer on each bolt put it within specs. Now I need a good front camber kit that will give me about 2.5 to 3 degrees of POSITVE camber to pass within specs so I can get a LEGAL Permit for my car to drive on Hawaii's roads... since they don't have emissions here, they have to get us in other ways..

Mark

 

[DGajre777]

Ingalls Camber Aduster +1.25° to +3°
http://www.extremepsi.com/store/customer/product.php?productid=18780&cat=927&page=1