After performing a boost leak test INCREDIBLE news Pictures Must see!!!

[GST98BIG16G]

After performing ill better say si just was tarting to perform my boost leak test , as i tried to pressurize system nothing happened , i was just hearing pssssshhhh from my bov , so i looked at it closely and decided to take it out . A year and a half ago a guy welded my hks ssq to my aluminium piping and i was sure it was working fine. There is a picture u decide , how my car ran i could put 2matches in the hole if not 3 ofcourse there was rubber seal , but it melted . The guy just welded through... im going back to him tommorow . It was fine but i had some issues on dyno and other ones like boost creep ,with my brand new MHI big16g We will see how its going to work after no leaks Thanks for looking happy new year!!!

 

[AutomagicGSX]

When I had my 1g BOV flange welded onto my XS power FMIC kit, I hooked up two seperate boost leak testers on both ends of the piping and pressure tested it to make sure.

Found some leaks in the weld and had them patched up

 

[GST98BIG16G]

i cannot believe it , i drove the car like this for almost 2 years.....

 

[jeffrey]

Probably ran like a stock 2g BOV hehe