what kind of bends do i need?

[opendown69]

i was wondering what bends i would need to do my own short route piping project for my car i am going with t3/t4 and i need to know what kind of bends i need to do it

 

[GVR4592]

http://store.racing-solutions.org/

This is where I got mine from. You need to figure out which bends you are going to need and go from there.

 

[calreef18]

Do some measurements on the car and then buy the pipe lengths/bends you need and cut them to fit. Don't forget to get some decent silicone couplers and some t bolt clamps or something else that holds strong.

 

[welfle18]

i have a picture of my ssautochrome short route piping i will post up maybe that will give you an idea..

 

[Midnightride]

what type of bend is going to depend on you intercooler as well. If you have the same one as in the picture then you'll know by looking at the picture. If you go with a FMIC where the inlet/outlet faces out (not like in the picture) then you will need other bends.

What i used was this:
2 U or J pipes from jegs to go around the side of the bumpers.
1 90 degree bends, one to go up to the turbo
1 bend that I got a autozone that was slighly bigger than 90 degrees(comes in a small section for exhaust work.
Few feet of straigh pipe.

Thats all I used.