Welcome to DSMtuners - The Talon, Laser, and Eclipse performance enthusiast resource
























Login


 Featured 
 Products 
 >>>>>> 
Go Back   DSMtuners > DSM Forums > General > Newbie Forum

Newbie Forum Beginner/newbie/general DSM questions. first mods, how to run 10's when you haven't run 12's yet, any tech question that doesn't fit in another tech forum. New Members must limit their tech posts to this section.

Reply
 
 
LinkBack Thread Tools
Old 10-17-2006, 01:26 PM   #1 (permalink)
Proven Member
 
From: brick, New Jersey
Region: Tri State
Registered: May 2005
Posts: 131
Classifieds Rating: (0)
Reputation: janks85 is an unknown
2G-specific 2g auto trans question

Ok so before anyone brings these up I did a boost leak test and changed plugs and wires and I feel it is the transmission..it seems to only happen in overdrive tho. When im driving at normal speeds it seems to miss but it isnt a miss it just feels like it and when I quarter throttle it, it has the same feel but worse sumtimes. it is hard to explain but maybe someone had the same problem..once i take off over drive it doesnt happen, it feels like it struggles back and forth in and out of overdrive(when in overdrive).. any idea how to fix or what it could be and help is appreciated

thanks
chris
Offline  

[posts] Reply With Quote
Related Auctions

Sponsored Links
Old 10-17-2006, 01:28 PM   #2 (permalink)
Proven Member
 
JayRolla's Avatar
 
From: Colorado Springs, Colorado
Region: Rocky Mountain
Registered: Feb 2006
Posts: 4,036
Classifieds Rating: (6)
Reputation: JayRolla is extremely helpful and trustworthyJayRolla is extremely helpful and trustworthy
If the tranny upshifts and downshifts out of overdrive than most likely its the tranny. Every time ive ever seen an auto do that the tranny was starting to go. I dont know how it would make you feel like it misses. Have you checked the tranny fluid and make sure the car is running when you check it.


____________________________
Jason ~ 6bolt/4bolt E316G @ 30+psi, Corn Juice
Offline  

[posts] [gallery] Reply With Quote
Old 10-17-2006, 02:06 PM   #3 (permalink)
Proven Member
 
blackbyrd's Avatar
 
From: Columbus, Ohio
Region: Midwest
Registered: Jul 2006
Posts: 688
Classifieds Rating: (0)
Reputation: blackbyrd is extremely helpful and trustworthyblackbyrd is extremely helpful and trustworthy
If your having problems with your overdrive gear, I'd replace your end clutch, from IPT's kit. I think it cost like 75 bucks. Start there, it's hopefully just a worn end clutch, that happens a lot to these cars.
And definitely check your fluid,change it, change your filter.
Offline  

[posts] Reply With Quote
Old 10-17-2006, 02:23 PM   #4 (permalink)
Proven Member
 
From: clarksville, Tennessee
Region: Midwest
Registered: Mar 2006
Posts: 125
Classifieds Rating: (0)
Reputation: twocanewayne is an unknown
Yep, fluid/filter change and see what happens.Then if need be do the end clutches.

Last edited by Defiant : 10-18-2006 at 01:32 AM.
Offline  

[posts] Reply With Quote
Old 10-17-2006, 03:10 PM   #5 (permalink)
Proven Member
 
From: brick, New Jersey
Region: Tri State
Registered: May 2005
Posts: 131
Classifieds Rating: (0)
Reputation: janks85 is an unknown
Yea, i was gunna do a fluid and filter change and hope it was that...and about how it felt like a miss..i was just trying to explain a feel everyone would know cause its somewhat compatible to what im feeling...but thank you again

also does anyone know what a round aout price is for a shop to charge for end clutch replacement

chris
Offline  

[posts] Reply With Quote
Old 10-17-2006, 03:30 PM   #6 (permalink)
Proven Member
 
blackbyrd's Avatar
 
From: Columbus, Ohio
Region: Midwest
Registered: Jul 2006
Posts: 688
Classifieds Rating: (0)
Reputation: blackbyrd is extremely helpful and trustworthyblackbyrd is extremely helpful and trustworthy
I dont know really what a shop might charge. maybe 200?You could call and ask them, they should be able to give you a good estimate, but It's really easy to do yourself..
Offline  

[posts] Reply With Quote
Old 10-17-2006, 04:34 PM   #7 (permalink)
Proven Member
 
From: brick, New Jersey
Region: Tri State
Registered: May 2005
Posts: 131
Classifieds Rating: (0)
Reputation: janks85 is an unknown
This is the first auto ive had i always owned 5spd's, so I wasnt sure if it was an easy task, does it involve dropping the trans or is it removing the pan near where the valve body is, I really appreciate the help

chris
Offline  

[posts] Reply With Quote
Reply






Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


All times are GMT -7. The time now is 03:36 PM.

Page generated in 0.12767005 seconds (73.48% PHP - 26.52% MySQL) with 9 queries
DSM Forums | Pontiac Solstice/Saturn Sky Forums | Evolution Forums | WRX Forums

© 2001-2008 SPEEDtuners Network, LLC All Rights Reserved

LinkBacks Enabled by vBSEO 3.1.0