Aluminum Intercooler Piping

[92 EcLiPsE]

I installed a front mount and it only included the left side (tb to intercooler), ### it was used. So I need to make the right side intercooler piping (turbo to intercooler). I have one of those cheap cold air intakes for my civic ex that doesnt fit. I needed a little bit of piping to finish my right side-intercooler pipe. Is it possible to use this kind of piping in a turbo setup? I believe its made of aluminum and its pretty sturdy. Anyone have luck with this material in their setup? How does it hold up to heat and the pressure?
Thanks in advanced tuners!

92 EcLiPsE

Edit: Oh yea I'm not going to be welding, I'm going to use silicone couplers at the 2 connections.

 

[slammed]

well it has to hold however much boost your running. It should be just fine...if it fits.

dejon has lots of good, cheap intercooler pipes for lots of setups.