Sheet Metal Intake Manifold?

Spoolio · 03-27-2006, 08:09 PM

Anyone installed one of these?, i seen em on ebay, also i seen proffessional ones also, anyone know what is needed to install this?, anything uninstalled?, anything like running an EMS?, or is this pretty much like a bolt on?, im not sure if there is any needed vacuums or sensors actually connected into the intake manifold?, anyone?,

blcknspo0ln · 03-28-2006, 01:32 AM

You've been here for 3 years and you didn't search for this? many DSMers run an SMIM and they are a great upgrade. Some SMIM's don't have provisions for a MAP sensor, resistor pack, and coil pack. You will need to find a way to relocate them if you decide to get an SMIM.

Spoon fed for ya.

http://www.dsmtuners.com/forums/sear...archid=1693033

fatso · 03-28-2006, 02:14 AM

bit of advice you will most likely get something that looks like a 2yr old put it together, you get no instructions and, well I could go on but .... I would advise getting one once you have really researched the good name brand ones, like magnus,adfx,venom. I learned the hard way and a intake manifold is one part I would not go cheap on.