The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

Post a Question

ECMlink BCS Not working! Bad ECU Drivers??

Please Support Rix Racing

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

PredatorSniper

PredatorSniper

10+ Year Contributor
125
19
Sep 16, 2012
Wichita, Kansas
So I installed the IR BCS from Link but the solenoid still isn't working. I did a battery test and the solenoid works. I checked continuity of the ecu wire into the engine bay, its good. So can I only assume since the ECU isn't tripping the ground signal that I have a bad driver? I went to the misc tab to cycle the BSC button and its not cycling or activating the solenoid, so before I send my ECU off to ECMLink to get repaired to you see any other conclusion on why this isn't working?
 
Add Value - Be Respectful - No Trolling - No Misinformation - Participate Often!

Similar threads

bo0st2
  • Question
ECMlink ECMLink Drivers Not Working on MacBook Air
Replies
6
Views
2K
DSM_15_2G
DSM_15_2G
ECU Drivers M5269L
Replies
3
Views
10K
dustyduff
Mike Bramall
General Ecu and moates not working, help?
Replies
0
Views
627
Mike Bramall
Mike Bramall
newtodsm97gst
isc not working
Replies
18
Views
6K
newtodsm97gst
newtodsm97gst
scantech not working
Replies
0
Views
847
giovanniv
Boosted Fabrication
ECM Tuning
ExtremePSI
FIBA Motorsport
Fuel Injector Clinic
Innovation Products
Jacks Transmissions
JNZ Tuning
Kiggly Racing
Morrison Fabrications
Rix Racing
RockAuto
STM Tuned
Support Vendors who Support the DSM Community

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top