Advise on rebuild ?

[eclipgst90]

Hey everyone...im wanting to make around 500hp with a built 6 bolt and my mods im currently running now...Please everyone check out my mods and then if i had a built 6 bolt would i be close to the power range i want...I would also be running dsmlink...Mods include.

-3" Apexi catback,test pipe 3" RNR o2 eliminator Downpipe ,SlowBoy Exhaust Manifold (PORTED), SlowBoy 3500 clutch,PTE SCM 6031 w/internal 36mm gate, Trust Manual Boost controller (20 psi), Walbro 255 HP (rewired), PTE 680cc Injectors, Gm MAF setup w/3" sensor ,Dejon Tool uip ,4"Dejon Tool Intake w/4" K&N , 31"X8"X3.25" FMIC W/ 2.5"Mandrel intercooler pipes ,Turbo Xs RFL bov, 12" electric fan w/160 degree thermostat
BPR7ES', Nology Hot wires, Palm M505 Color datalogger, Short throw shifter, VIS Carbon Fiber Hood, Eibach sportlines, Drunken Bear rear camber arms, Gunmetal 2g gsx wheels w/ Brand new Tires, Autometer Boost and Air Fuel, Nology Hotwires Plug wires!
- I need advise on what internals to purchase and what head work to get done...MY spending range is between $3,500 and $4,000! Enough?...Im not lookin to do anything with the tranny yet just motor! So what internals and head work i should get...Will i make the power with my mods i have now with built motor and will the money im workin with be enough...Thanks Everyone

 

[dsmputz]

Call Slowboy up and ask for a deal on eagle rods and some wiseco pistons, you could probably get them for about $700. I just bought that exact combo plus spent $1030.76 on machine work. For that 1000 bucks I had my shortblock hot tanked, magna fluxed, bored 20 over, decked, line honed, balanced the rotating assembly, and completely assembled by a pro(no plastiguage). Then spend the rest on your head, I don't know the cost estimate on that as I haven't done it yet myself.

Robby A

 

[eclipgst90]

What did u do just send them ## stock block?

 

[dsmputz]

Sorry, I should have clarified. I bought the internals from Slowboy but had a local engine rebuilder do all the machine work and assembly. If your gonna get someone local to do it make sure he has a good rep, some guys really don't give a shit about your stuff.

Robby A