? about buschur stage 1 block

[fastalon]

Ok i have a buschur stage 1 block, but the problem is that one of the pistons is fried. Not to mention it took out the piston wall , so now i gotta have that sleeved, but thats anouther story. So now my question is? if i order new 95 pistons do i have ot have them machined for the 1g rods, or is it vice versa. or do i have to machine the rods to fit the pistons, so in that case i would be fine then right?. Any info would be appriecated.

 

[fastalon]

come on some1 has got to know.. cause i sure dont

 

[fastalon]

ok what i need ot know is , will the new 95 pistons i buy fit on the one g rods in the block allready. Or do i have to machine the pistons to fit that is what i need ot know???

 

[gsxspeed98]

In order to fit 2g pistons onto 1g rods the wrist pin bore on the rod must be opened and the pin end of the rod must be narrowed. So the rods must be machined.

 

[fastalon]

yea so that means im fine then casue the rods in the motor all ready were machined for 95 pistons, its a buschur stage 1 block. thanks gsxspeed.

 

[gsxspeed98]

no problem.