6 bolt swap cuz of crankwalk questions

[Blitzed95Eclips]

I have a feeling my car is starting to walk. I hear a loud ticking noise under the valve cover. Also the pressure on my clutch pedal changes every so often. It also gets sort of stuck sometimes and i need to pull it out using my foot. So i want to get a more reliable motor and i figure if i start now i will be prepared for the worst. I hear the 6 bolt swap is what is best. I did a search but i couldnt find much. Could someone point me in the right direction to learn basic knowledge of this swap. I would like to know where i can get the motor, how much it will be, and what all i need to do to make it fit. Thanks a lot for your time guys.

 

[L2RTSiAWD]

If you searched you would have found a shitload of info on it.

Also join the 1gina2g yahoo group

 

[Blitzed95Eclips]

i cant do a search for "6 bolt swap" because of the stupid search rules where you need 3 letters. Could someone point me to the right thread.

 

[Streetbeat]

go to magnusmotorsports.com theres a tech article about a 1g in a 2g

 

[RocketBoy]

Check out www.roadraceengineering.com as well, look under the tech section.

 

[Blitzed95Eclips]

Does anyone know where i can get the motor. My ticking is louder then hell. I can hear it over my 3 inch turbo back exhaust. I have a feeling my motor is going to take a crap on me any day now.

 

[kr.k]

Originally posted by Blitzed95Eclips
Does anyone know where i can get the motor. My ticking is louder then hell. I can hear it over my 3 inch turbo back exhaust. I have a feeling my motor is going to take a crap on me any day now.

I am no expert but shouldnt you stop running it to save your rods and pistons etc.?

 

[BenieMan]

http://www.roadraceengineering.com/4g63motorsearch.htm

 

[BenieMan]

as kr.k says, you def.. def.. definitaly should NOT be driving your car unless you want to be stranded..
My crank walked, and I got a new short block from Mitsubishi dealer.. it's a pain in the ass, so I feel for ya.. I've been through the same thing.. the clutch thing feeling soggy, and not coming back up is all tell tell signs.. good luck dude

 

[Blitzed95Eclips]

Ok here comes more serious questions
1. if i drive my car till it breaks is anything serious going to break that i will need to use on the 6 bolt swap
2. I found a local place that sells engines. If i buy the 6 bolt engine is this all im giong to need? Or will i need to buy the install kit that magnus sells?
3. I also found a NT talon 6 bolt. Is this the same engine as the turbo model just without the turbo? Would this work? All that is wrong with the talon is that it has a bad tranny and its only 600 bucks for the hole car. What else would i need to get?

Thanks a lot for your time guys. I greatly appreciate it

 

[FourG63 97GST]

http://www.roadraceengineering.com/2g6boltmotorinstall.htm