Taylor 10.2mm Wires

[larryd]

I have a set of these wires and for some reason the boot on the #2 cyclinder keeps popping out and causing the car to misfire. Does anyone else have these wires and have a suggestion on how to keep this from happening?

 

[95GST]

could you maybe crimp the connector inside a little to make a tigher fit?

what do you think of these wires? Any difference than the magnecors? Yeah I know about the low resistance blah blah, but actually any difference you can feel at all?

 

[Dieselboy]

Those arent the only ones. Magnecores, MSD's, and some stockers do that too. Yeah, how are those frickin HUGE ass wires?

 

[larryd]

I dont notice any difference in the wires myself. When you push the boot down its a solid fit and it suctions down like its not coming back up but it pops up when you get on it.

 

[98TsiAWD]

Originally posted by larryd
I dont notice any difference in the wires myself. When you push the boot down its a solid fit and it suctions down like its not coming back up but it pops up when you get on it.

Is your VC leaking oil in the spark plug? Maybe you have some crankcase pressure and that is where it is venting out and pushing the boot off

 

[95GST]

pack the connecter good with some dielectric grease, that should form a nice suction. Yes, ghetto but it may work.

 

[doug]

Could a spark plug that's not torqued down enough allow enough blow-by to cause this?