Turbo timer w/alarm install ???'s

[jonnygsx]

Ok, I have an after market alarm installed on car. I want to put a turbo timer in but the 12v constant and 12v ignition wires are spliced for the alarm. The starter wire is cut and a wire (im not sure what) is run from one end to the alarm box and then back to the other end of the starter wire.

--starter wire--[alarm box]--starter wire--

My question is in regards of where to tap for the turbo timer wires. Do I need to tap before or after the alarm splices/taps? Or does it even matter?

Jon

 

[92tsiawd84]

Do you have a harness for your turbo timer? I bought a harness for my car with my hks turbo timer. If you have the harness (atleast with hks type 1) all you do is remove the connector from the ignition, plug it into the turbo timer harness, and plug the other end of the harness where the old one was. I do not have an alarm (yet) but I have read that there are other things you have to do to get them both to work.

 

[FourG63 97GST]

yea its a bit tricky to get the timer and alarm to work in harmony,
I have my alarm set so it will arm as soon as the car shuts off.