When I have the money...

[Tsigoon]

I found a place to get a 2.4l GVR4 block- Will this fit with a 2.0 l head? I'm not too great with the whole what matches what, so will I have to get a GVR4 head? I figure IF I can do it with a 2.0 l head, my setup in the next year will be:

Ported/polished 2.0 1g head/oversized valves
2.4l GVR4 shortblock with forged internals
Evo III exhaust manny
16g set to 16 psi
EvoIII O2 housing
550's
Walbro 225 lph
SAFC
3" mandrel bent with a dynomax bullet
FMIC
cold air intake
25-50 shot NO2
Light flywheel
Act 2600
Short shifter

Am I leaving anything out? Any suggestions? Any Idea on how much HP i'll be pushing?


Oh yea, and lots of stickers- I hear those are like 100 bolt on HP each.

 

[gst_spyder]

Magnus MS just uses the 4g63 block (6 bolt) and puts in a 4g64 (2.4L) crank with forged internals. You may want to give them a call, go to www.magnusmotorsports.com. Oh and the GVR4 motor is a 4g63 not a 2.4L.

Mario

 

[larryd]

when i have the $$ Im getting a Porsche 911 Turbo

 

[cmc]

Oh yea larryd, when I get money I'm getting a ....hmm...don't know, never think I'm going to have that much money.

 

[larryd]

hahah tru..

 

[ted_the_mexican]

when i have the money i wont need to post on the forum cause i'll be able to hire someone to show me how instead of hours upon hours of reading.....

man my head is starting to hurt from the computer screen

daawell like i'll ever have money...

 

[All4Smoking]

"I'll tell you what I'd do man, two chicks at the same time man, hell yeah." - officespace

 

[Atari007]

Originally posted by All4Smoking
"I'll tell you what I'd do man, two chicks at the same time man, hell yeah." - officespace

.... officespace kicks ass

 

[larryd]

how funny is that.. i just watched that movie again last night