fmic on laser

[laser001]

Does anyone have a fmic on their laser? I've looked under the hood and under the car and can't see a way to fit one w/o chopping the sh#@ out of the front end.

 

[IPT]

On my talon all I had to do was leave out the front bumber. No other changes where needed. Wait I did enlarge the hole next to the radiator to get my IC piping thru, but you do not have to run your pipes that way.

 

[Jason_Crowe11]

I have had two fmic's on my '92 Laser.

The first was a starion style core>>with custom 2" piping. the bumper was not touched>>the bumper support piece was hacked up slightly to fit the core properly.

Now I have a Much larger Extreme Turbo FMIC with custom 2.25/2.5" piping>>and we had to virtually eliminate the center portion of the bumper support--also had to trim a chunk off the pssgr side of the bumper>lower portion>>>only because of how my piping was routed though.
Oh yah, and we eliminated the power steering line that runs in front of the radiator> just have the pwr steering going out of the tank and back in now. Works fine.

Hope that helps some.

Laters
Jason.

 

[Jason_Crowe11]

Here's a pic. of my Extreme Turbo core on the car as it is now:
LASER FMIC

Laters
Jason.

 

[laser001]

Thanks, I'll have to get a better look after I pull the motor.