Which Aftermarket BOV's fit the 1G flange

[hellotbone]

As the topic states and I want to recirculate.

 

[90blacktsiawd]

I know that the greddy type s can be used by drilling 2 additional hole in the flange and it can recirculate. Im sure the new greddy type rs uses the same flange but i dont think you can recirculate it.

 

[big green]

I have seen the Type RS recirculate, you have to rig it up on your own tho. If it was me I would just stick with the 1g bov

 

[hellotbone]

The problem is the 1G even crushed leaks so on deceleration is whistles like a train whistle well not that bad but close.

 

[Turbo Talon DL]

There are places that sell 1g flange bolt-on adaptors. HKS SSQV has an adaptor flange that bolts to the 1g flange. It comes seperate tho.

 

[CanadianTSi]

The forge BOV bolts directly to a 1G flange...I have one, there pretty lound considering it's recirculated. SBR carries them.

 

[90blacktsiawd]

How do you like yoru forge bov? Ive been lookin into them but nobody i know has one. How much boost are you runnin? How does it sound?

 

[hellotbone]

The forge one does look good after I get back from holidays this week I'll order one.

 

[CanadianTSi]

How do you like yoru forge bov? Ive been lookin into them but nobody i know has one. How much boost are you runnin? How does it sound?

I like it, it looks good and fit well. I think the spring that is it in is to tigth because under low boost when it blow's off it makes a high pitched whistle sound, but under high boost (20 psi) it kinda sounds like a HKS SSQ but a bit faster, sounds good though. Extra springs came with it so I guess I'll just have to try a different one.