Lotek Pod install Q

[Clipse]

Does anyone have the lotek triple or double pod on their 2g? If so, how in the F##king hell did you get the bottom screw in the A pillar? I have tried to get in there with 3 different kinds of drills, and all I have accomplished is scratching the pod itself!

If you have succeeded in doing this, please share the wealth!

Thanks

 

[Clipse]

Damn, guess that was a lame question

 

[TSiAWD666]

I lined up the a-pillar pod and used the tip of a drill bit to scratch the paint where I wanted to drill the hole. Then I removed the a-pillar and drilled the hole. I don't know what more there is to say... it's about as simple as you expected it to be.

 

[tqlla]

I put the screws in the pillar with Toothpaste on the bottom to mark the holes. Then drilled away.

Unfortunatly the toothpaste may have caused the surface to be slippery, cause that drill went everywhere. The Pod is near where it needs to be... but not perfect.


All I can really say is good luck!

 

[TSiAWD666]

Toothpaste? hahaha nice one Macguyver

 

[chriw21_2000]

Drill the hole in the pod if not already done. Take a center punch to mark the hole and then remove the pillar and drill away. This will mark the hole and keep the drill from walking.

Laterz