AFC center vent housing

[20psi]

I finished my AFC housing.Notice how I set the angle towards the driver.I used a black texture coat to give it a "factory look".You can also have a bodyshop paint it if you like.I can crank out them a little faster now so I was able to drop the price to $150 shipped vs.$250 + shipping

 

[InfamousEclipse]

looks real nice but what gauge is that up top? Can you even see it that far away?

If you did an SAFC/ Gauge mount for the center in a 1G I'd buy it

 

[20psi]

It's my egt gauge and yes I can see it.I would need to make a mold for a 1g, I'll see what I can do.

 

[dave99gst]

looks good !

( still cost more then the $105 shipped i charge

its more work then people realize aint it ?

 

[laserboost]

I've seen vent pods that hold an AFC and gauge advertised here in the classifieds for cheaper prices, not sure if they're as good quality.

 

[20psi]

I use fleece stretched over built quarter inch MDF frames. Filled with rage gold and sanded from 80 grit all the way to 2000 grit sandpaper. I have a few customers on this site who can back my work.I don't use fiberglass cloth because it deforms over time.
NIIIIIIIIIIICE!