cost estimates on turboing

[Sephroth57]

i have a 2.0 DOHC 1g NT, what would the cost be to turbo it? including all internals and what not that i need to replace

 

[Sephroth57]

not including install price just for parts

 

[97eclipsedGS]

exhaust manifold (used) 150
pistons and rods 600 min.
piping (used) 100
bov 200
turbo (16g or better) 700+
downpipe 300
turbo cams 400

hope this helps a little bit..... im a 420a guy, so these are just rough estimates and it is a vague outline of stuff you will definitely need....

 

[Sephroth57]

damn, i think ill just wait till i can buy a GSX heh

 

[fast1.8sohcDSM]

Those prices are way out of proportion. I bought my stuff so far:

JE Pistons 500.00 with Rings
Turbonectics Rebuilt T3 60 Trim 378.00 shipped
Super AFC II 325.00 Shipped
Autometer Ultra-Lites[AF, EGT, Boost] 271.00 Shipped
G32B Exhaust Manifold 100.00 Shipped
and T3 Flange 19.00 Shipped
Shear Head gasket Quite a bit. It is still being made.
Top-Line full gasket Set 121.00
I bought all that stuff from Ebay, except my JE Pistons, Shear Head Gasket, and Top-line full gasket set. Your prices will be different, and some easier to come by. But really, lets not go overboard on some of those prices, you can get a stock 1G BOV from Dejon Tool for like 75 bucks or so.

 

[laser9320]

So far I have spend a little over $1000, but I'm also building a 6-bolt. I estimate I need about $700 more to finish off the engine, but if your just putting the turbo on an existing engine you could do it for $1000.

 

[supergoat]

I found a $500 donor car.

 

[SilverEclipseT]

About how much would it run for just good internals (i like to do it right the first time). No labor just parts? And what do yo recommend the best setup.... Bore compression. etc i plan on running about 15psi in the future