motor help needed any comment welcome

[s2000b4idie]

hey i am having my motor rebuilt by a local machine shop and they are somwhat incompatent what do i need to tell them so they understand what i want. i want to run a n/t with 10.5:1 compression and have it bored 20 or more over. i want it to withstand a 100 shot of nitrous without blowing to peices so i figure i will need new rods. lastly i am having the balance shafts removed because this is what they recomend and the cams degreed because i dont know how to do that either. any input on what im doin is greatly appreiciated . thanks





sam

 

[s2000b4idie]

does any one even have a coment??????????????

 

[TimG]

Originally posted by s2000b4idie
hey i am having my motor rebuilt by a local machine shop and they are somwhat incompatent .... any input on what im doin is greatly appreiciated . thanks

Incompetent - Inadequate for or unsuited to a particular purpose or application.

If they can't do the proper job, don't give it to them to do. Best advice right there for you.

 

[green95hrcgs]

Yeah dont give the motor to them to build. Go with a shop that knows what the hell they are doing.

And personally I would be scared to run 10.5:1 compression ratio WITH nitrous. That doesnt seem to be a very freindly combo unless you pay close attention to tuning. I would feel safer with a lower comp ratio.