2G SBR FMIC Blow Through Question

[BOOstGhost]

I did a search and couldn't find any info. I bought an SBR FMIC for my 2g a couple years back. I now want to run a blow through set up. I was wondering if I want to switch over if I need just SBR's UICP or do I need to buy another throttle body elbow also? I know I could just shorten the piping I have now, but it seems like I might to cut where my current flange for my BOV is located. I tried emailing them about it and they just sent me an estimate for $600 in parts.
-adam-

 

[SBR Joe]

Adam,

Do you already have the MAF and translator? You can cut off 5-6" or so of your pipe like you stated and that would work fine, you would just need to re bead the pipe so it wouldnt blow off under boost. You would also need the new TB elbow because its at a different angle than the standard one along with the couplers and clamps to accept the GM maf. Shoot me a pm if you would like so we can discuss what you need to make your setup work.



Joe
SBR

 

[BOOstGhost]

thanks for the response. I just sent you a PM.
-adam-