AGP RS49T wheel size

[madman]

Does anyone know the Inducer and Exducer specs of the Turbonetics wheel?

I have a RS49T and want to put in a different CHRA in a need to know if it will fit.

 

[brute]

Compressor Wheel Diameter - 54mm

Compressor Wheel Inducer - 2.123"

Compressor Wheel Exducer - 3.000"

Do you need Turbine Wheel stats also?

 

[madman]

I think I'm ok on my turbine side specs.

I've seen those numbers on other turbos too, so I guess most all 50trims are the same?

 

[bfdahl]

I was thinking of doing that to my RS49 too. and installing a 57 trim BB chra.

I thought, with my luck id buy it and the thing would touch the housings somewhere and they would not take it back.

Ive also wondered it theres CHRAs use and o-ring on the compressor housing, and if the Turbonetics cover would seal right if the CHRA has an oring in the kit.

I have also thought about this angle:

New PTE turbo: 1200$ ish + sell old turbo for 450$ or so. im out like 700$ and everything works.

Vs, buy CHRA 660$ and take the old stuff apart, hope it all fits and works

I think id rather buy a new one

 

[brute]

The compressor wheels are the same size. The only thing with a different brand is the compr/turb housings. So if something says "50 trim", that means it'll be the same size. 57 trim, 60-1, etc. are all the same from different companies.