A/F gauge

[Newlogics]

Hi guys,
I'm trying to install A/F gauge, but page on finding sensor wire is missing on VFAQ...
There are 4 wires going from 02 sensor (2 whites, black and grey)
(I assume it's o2 sensor, since they are going from o2 housing)

Which is the one to tap ?
I don't seem to get any reading from any of them...
One of the whites makes gauge go all the way to reach end and sit there, so I don't hink that's it. All others don't give any readings at all...
Heap please....

 

[DookGST]

I thought you tap a wire in the passenger kick panel on the 1g's

 

[Newlogics]

ANy idea which one exactly ?

 

[KaNe96]

Here is a website that shows you were to tap the o2 on the ecu harness....


http://www.roadraceengineering.com/instructions/afmeterinstallinstructions.htm

 

[gvr4#1375]

You have to do it from the inside of the car, because the engine bay produces a lot of heat and if you tap it from the 4 wires on the sensor it will melt the plastic from the wire tap. Eventualy it will not work.

 

[onegee]

i seen a link that shows where to tap the o2 test sensor wire in the kick panel...since that wire has a female adapter on it, could i jus wire my a/f gauge (autometer) to a male connecter and connect them? or would that not work??

 

[onegee]

http://www.myzero.com/electrical/find-o2.html

thats the link right there.....so could i?

 

[whooride98]

Since we are on this subject, I was wondering if anyone can answer this question for me? I'm looking into getting a air fuel gauge for my car and i have a triple pod on already and had talked to a couple people about that there is a kit to make one of your a/c vents to fit your air fuel gauge to go into. I just haven't seen one yet but i have seen this done to many 2g's i have seen around and at shows. Just curious.


"This ain't no joke"