What Dyno #'s

[cazual]

Hey guys, I am going to the Dyno tomorrow and I want to know what you all think looking at my sig what kind of numbers I should be looking for with my setup. Thanks





"3" Thermanl catback exhaust; "3" custom down pipe with test pipe;16G Turbo; Unorthodox under pulley; 2600 lb ACT clutch and light weight Fidanza flywheel; Walbro 255HP fuel pump rewired; HKS EZ boost controler; guages; SX fuel regulator kit; Ported EVO Manifold; Ported EVO O2 housing; DSMtranslator;SAFC II; logger; ; Buschur FMIC; Tial BOV; 660s.

 

[candela]

Depends on type of fuel, boost, temps, what type of dyno...etc

But if all is right Im sure that if tuned good on race fuel and mayb 22-25psi you could get from like 300-320whp...

 

[cazual]

Thanks, I will by using C16 race gas, on an awd Dynojet.

 

[Violater101]

Just don't be disappointed if the #'s aren't what you expect. Most of the battle is tuning. How much max timing are you getting? EGT's?

 

[kpt4321]

If you're using race gas, I would be very dissapointed to see you only make 300 whp.

My car, with a 14b, 2.5 inch exhaust, 450's, and no fuel control, trapped at over 106 mph. That's about 300 whp.

I would hope you would make between 350 and 400 WHP on race fuel.

But, this only will happen if you know how to tune.

 

[cazual]

Well, I am back from the dyno and I was unable to run the race gas so I had to make my runs with pump. Anyway, after a couple of hours of playing I managed 301.9 whp and 291.6 torque at 18psi.

I was really and I mean really rich at the top, but we just did not have the time to lean it out enough to see if my numbers would increase. I will make some more runs this coming Friday, to see if I lean her out at the top end.

 

[kpt4321]

That's not too bad!

See, I told you you'd make more than 300 whp on race gas.

I look forward to seeing what you can do next time!

 

[cazual]

Originally posted by kpt4321
That's not too bad!

See, I told you you'd make more than 300 whp on race gas.

I look forward to seeing what you can do next time!

Thanks Kyle. I will let you know.