maybe the disk is exedy? the pressure plate sure isnt

hey that looks pretty damn sweet. Will you be needing that intake manifold? if not, PM me. id also say the pressure plate is a stocker. that engine looks very nice. good find.

that turbo is an evo 3 16g

you can tell by the (16g6) thats the name of the compressor wheel

project_tsi said:

hey that looks pretty damn sweet. Will you be needing that intake manifold? if not, PM me. id also say the pressure plate is a stocker. that engine looks very nice. good find.

Click to expand...

actually, i couldn't figure out how to use the evo intake manifold - it seems that the throttle body is backwards

What's the vin number off the block?

Look at the pics of these two EVO III engines, the throttle body linkage and TPS should be in the same spot as a DSM.

http://www.lancerregister.com/reg_c...php?carid=425#/
and
http://www.lancerregister.com/reg_c...php?carid=304#/

Note the upper engine puller bracket as well, it's not the same as the engine in your pic.

The picture you posted of the turbo is a 16G but it's not an EVO III 16G.

An Evo III 16G has 49178-01 cast into the compressor housing and the numbers 470 stamped right after, so to read 49178-01470.

If you post the VIN I can check it with the Japanese CAPS program I have.

Either someone took the good parts off before you got it or that's not an EVO III engine.

-Richard Silva-
'93 Talon TSi

timm98gst said:

actually, i couldn't figure out how to use the evo intake manifold - it seems that the throttle body is backwards

Click to expand...