Has anybody already done this work?

[tpi_roc]

Has anybody "blueprinted" the suspension components of a 1g dsm?

Control arm lengths, control arm angles, SAI angle, ride height, scrub radius, etc etc? I'm hoping that some, most, or all of this information is available somewhere. If not I'm going to have to try to make an effort to shady tree measure most of it for determining roll centers, dynamic camber curves, etc. I'd rather not.

If you have any measurement at all please post it here. If you're trying to remain competitive in your region and don't mind sharing with an enthusiast not in your immediate area you can PM me and I promise not to share it.

Thanks

 

[turbosax2]

I know this site is for a 2g but his idea was creative and maybe you can contact him for other ideas.

Far North Racing - Suspension Modeling Project

 

[mavisky]

Not to my knowledge. I'm wanting to take some measurements on some of the rear components of my fwd, but that won't help you at all.

 

[talonTSIDriver]

I know this site is for a 2g but his idea was creative and maybe you can contact him for other ideas.

Far North Racing - Suspension Modeling Project

I've been debating on buying the software that FarNorthRacing used.

The WinGeo3 Basic Independent Suspensions software is only $200, not too bad, but it would be nice to have the full version, but for $1900 I dont think I would utilize it that much.