2G Clutch problem.

[awd936]

I recently went to my car to drive my car home from my friends house. I got in and engaged the clutch and it went to the floor very easily, when i let out the clutch to start goin it cought really really low. Right near the floor. By the time i got home there was no clutch at all. The night before, the car was fine. What could this be?

 

[underpressure25]

How many miles are on the clutch? How is the clutch fluid resivoir? If your clutch fluid is low your clutch slave cylinder or your clutch master cyl or one of the clutch lines could be leaking and will need to be replaced.
Good luck

 

[4thsydecustoms]

is there more thatn 1 resivoir for the cylinders?, or more than one place to bleed from?

 

[Rx3]

Check for leaks as has been mentioned above. Check your master and slave cylinders. One (or both) could be bad/going bad. Check the floor on the driver's side near the pedal and look for seeping fluid. If you see any fluid on the carpet in or around the clutch pedal, definitely change the master and slave cylinders.

 

[LunarEclips]

sounds like the clutch is going....sticky clutches usually results in a bad clutch. First check for leaks like everyone is saying. But clutches are more common to go out before a master or slave cylinder does...

 

[awd936]

My clutch has about 600 miles on it so i know its not the clutch. I checked the fluid and there isnt any in it, so im thinkin theres a leak or soemthing, but i cant find were, I will be goin to get some fluid. Whats the best way to check for a leak? Put the fluid in and pump the clutch? Thanks