Removed ABS wheel sensor, now car won't start

[MG200]

I am removing the ABS system off my car and started with first removing the sensors on the wheel knuckles. I was able to uplug the rear ones but the fronts I just cut the wiring (right where it goes into the fender).

Well now my car doesn't start. The engine does not turn over. No power windows, locks, stereo when I key the ignition. When I key the ignition to start I hear a clicking under the hood.

I checked all the fuses and everything looks fine. I am stumped at this point.

I want to continue to remove the rest of the ABS system including the computer control unit. Anyone done this that can help?

 

[GORBS88]

I have done this to my car too....was pretty straight forward....the only thing i can think is check you battery terminals..the abs pump gets power right at the battery..mabe it came loose when you unhooked wires...pm if you need any help...

 

[Old Mitsu Tech]

You must have left something loose. Like was said, check around your battery. Get your handy digital multimeter and start checking voltages. Should be pretty easy to find.


Good Luck

 

[MG200]

Thanks for the help. It was my battery, somehow it got drained!!