a/f gauge no wire in slot for tap???

[LRS95TSI]

when i started to install my a/f gauge i noticed that there was no wire running into the slot of the ecu where im supposed to tee into with the signal wire??? what should i do???

 

[Defiant]

Look again, you're in the wrong slot.

 

[Sean485]

Remeber most plug config diagrams are based as your looking at the "back" of the connector, IE the side the wires go into, not the side the ecu is on.

 

[flinguist]

This link should help you out. It shows the ECU pinout. http://www.prostreetonline.com/pso/pages/techtips/showarticle.asp?articleid=13