Help Ecu signal outputs

[Prodigy]

Does anyone know the signal outputs for Water Temp and Camshaft position sensor output...

i have no idea for camshaft.. any help would be great thanks..This is for the Sbc-id harness install..

Water Temp

Low(v) 1.20
Fit 80.00
High(v) 3.50
fit 20.00

 

[SlowSpyder]

sensors are inputs not outputs. Are you asking what wires to tap into for that boost controller? If you are, the Engine coolant temp sensor is #83 and the camshaft position sensor #88

 

[Prodigy]

Cam signal it's a square wave with frequency proportional to the engine
speed.

Water temp it's a thermistor with a pull-up to 5V acting as a resistor
divider.

Thanks but i know which wire...

From what i understand the low side of the cam is 5v and the high side 29.6v

 

[SlowSpyder]

ahh, you were talking about sensor signal outputs. Sorry about that, looks like you figured it out unless you want what the resistance for a typical thermistor. Tell me if you need the values for the voltage/temp/resistance for the ect because I have access to an osscilliscope. Sorry about the misunderstanding

 

[Prodigy]

well if you could check for me it would be great....i think this is something more ppl would like to know in the future...