Effed up and tapped manifold for 1/8th, do they make 1/8 fogger nozzles?

[compression]

I could have sworn up and down that fogger nozzles were 1/8" but looking at a buddies they look half that, 1/16th or something. what can i do? could i run a reducer for the nozzle , do they make that? its a jmfab race with nitrous bungs. please help my stupid ass before i mess anything else up.

Edit shortly after posting i searched and found the correct size nozzles, "whew" i was starting to panic

http://www.nitrousdirect.com/nozzles.html

is the site i found them on.

 

[JusMX141]

The solution to this would have been to plug the hole with a 1/8" brass hex pipe plug....then drill and tap the center of the brass hex plug for whatever size you needed.

 

[compression]

what size are most of the nitrous fogger nozzles?

 

[Nate Crisman]

what size are most of the nitrous fogger nozzles?

1/16-27 is the thread for NOS brand foggers. I think NX brand foggers are 1/8"NPT thread.