An size fittings on stock fuel rail?

BlackViper · 10-17-2003, 02:14 PM

I was wondering what size the fittings are on a 2g stock fuel rail? I'm replacing pretty much all components of my fuel system as something is very wrong with it. I won't need to get bigger size fittings anytime soon so I'd like to just get a new fuel rail. So I just need to know what the size is. Thanks for you time.

BlackViper

BlackViper · 10-17-2003, 07:13 PM

I wouldn't think this question is too advanced for the general/newbie forum. I guess I'll try the performance one. Thanks for nothing.

BlackViper

doug · 10-17-2003, 08:10 PM

I think the reason you didn't get any replies is twofold:

1) You only gave it five hours

2) The question was a little vague. I'm not quite sure what you're asking, but I'll take a shot at it (despite the 'tude):

The fuel rail doesn't have AN fittings on the end of it. Although you can get adapters for the inlet and outlet from AutoAlchemy and some other places that convert it for use with -6AN line (-8 is also available, I think). The stock lines are one piece from the fuel filter to the rail, and from the FPR to somewhere (I'm not as familiar with the outlet side).

If you're asking what size bolts go into the holes on the ends of the rail, I don't know that either, but it shouldn't be too hard to figure out.