tial 44mm wastegate problem

[guitar3228]

ok ive searched and searched, i need a proper vacuum diagram of how to set it up PROPERLY using a manual boost controller, i just bought the car and suspect that these vaccum lines may not be properly hooked up... ive looked and looked but im still confuse how to do it with a manual boost controller.......please help dont yell

 

[Staytuned]

http://www.tialmedia.com/documents/w3_tial_wginstall.pdf

Here is what I followed.

 

[guitar3228]

so you have the MBC hooked up between your top and side ports on the wastegate, and tee'd off to the intake? then what about the BOV?

 

[Staytuned]

BOV should have it's own pressure source.

 

[Staytuned]

so you have the MBC hooked up between your top and side ports on the wastegate, and tee'd off to the intake?

Yes, I have a pressure source tee'd off with one line going to the WG solenoid and one going to the WG.

 

[guitar3228]

whats the vent for in the vacuum line by the top of the wastegate?

 

[Staytuned]

Not really sure what that is for ..... but it makes no sense to actually vent air out there like that. I have no vent between the boost solenoid and the wastgate.